|
This is where we make cool little tools for nowt!
All items are for the 400/450, they may also be for the other models.
To confirm differences check out your bike's sector at the bottom.
Light blue for 470/501, light yellow for 550/650.
Husaberg 400/450 Models
FCR Pilot screw adjuster: Getting to it from underneath. You need a block connector (UK), an electricians screwdriver and 10 minutes work. What you see below is an expensive peice of kit!!!!
It's a block connector, cut in half with a electricians screwdriver in the end. And in that hole on the right is the pinch screw!
This is a plug cap that was ground down on the outside and it locates on the screw and can't fall off!
Here is thread full of handy tools! UHE forum thread
Feeler gauge
Handy feeler gauge for adjusting valves on the Berg. This one's from JoeUSA.
Undo valve inspection cover
 |
IKEA allen key seems to do the job.(Arkley123)
|
Crankshaft locking bolt
 |
Again from JoeUSA
|
Shock rebound adjuster
 |
This is Viking's tool, non-slip too!
|
Waterpump shaft cover
|
|
When fitting the sidecover, it needs to fit over the waterpump shaft without being damaged., that way the seal will remain good. (Husabutt)
|
Brake bleeding
Barry rates these Speed Bleeders for a DIY brake service!
Stator Pullers - Oem
There are two types of puller, one for the SEM and one for the Kokusan engines.
Work stand
 |
Pivoting workstand sure is handy. (Neil_E) |
Clutch and crankshaft locking tools
 |
Factory tool not in stock? Rivet two plates together. Need a gear holder? Cut up an extra primary gear. (Neil_E) |
 |
Tools |
Splitting the cases
 |
engine case puller (Neil_E) |
More pullers
 |
bearing race tool, balancer puller, timing sprocket puller (Neil_E) |
Working on the crank
 |
Crank Stand 1 (Neil_E) |
 |
Crank Stand 2 (Neil_E) |
| 
